Riso CZ180 Series Technical Manual page 177

CHAPTER 13: PANEL MESSAGE
Error Type P03 [Clamp motor lock]
P03-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Press Reset Key
display
Error Point
Clamp sensor is OFF after the completion of the clamp unit initialization or home positioning
500
movement.
501 Clamp sensor does not go OFF within 1 second from the time the clamp motor operates.
502 Clamp sensor does not go ON within 2.5 seconds from the time the clamp motor operates.
504 At the start of Clamp plate open action, the detection of clamp sensors is OFF.
At the start of print drum Position-A compensation movement, the detection of clamp sensor is
505
OFF.
506 At the start of Clamp unit Home-positioning movement, the detection of clamp sensor is ON.
507 Clamp sensor is OFF after the clamp open action is completed.
508 Clamp sensor is ON after the Position-A compensating movement is completed.
515 The Drum is not in the Position-A nor in the Position-B when the Clamp motor starts to operate.
Error Type P04 [Ink overflow]
P04-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Press Reset Key after correcting the ink overflow condition. (No ink on the ink overflow sensor.)
display
Error Point
The overflow sensor is ON for a set number of times in succession during the 10-millisecond-
513
interval overflow-sensor check.
Error Type P05 [Vertical print positioning pulse motor lock]
P05-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Press Reset Key or turn the power OFF and ON.
display
Error Point
The vertical-centering sensor does not switch ON even when the vertical-positioning pulse motor
603
activated in the image-down direction for 5.0 seconds during vertical home positioning movement.
The vertical-centering sensor does not switch OFF even when the vertical-positioning pulse motor
604
activated in the image-up direction for 5.0 seconds during vertical home positioning movement.
Even though the vertical positioning motor stopped according to the vertical centering sensor
605
detection, the stopping position does not correspond with the programmed position.
612 The print positioning key is pressed with vertical-print-position information undefined.
RISO Inc. Technical Services & Support
Error Conditions
Error Conditions
Error Conditions
13 - 8 CZ180 / CV1860 Rev. 1.0
US.RISO.COM