Riso CZ180 Series Technical Manual page 106

Precaution in Assembly
) Use the Drum Shaft JIG when mounting the screws back onto the Drum shaft clamper.
( Dram shaft Jig = 05-2628-008 Drum Shaft JIG )
2) With the Drum at position-B, insert the Drum Shaft JIG through the Front support plate, Drum
flange-F, Front frame, Rear frame, Drum flange-R and Rear support plate. Then tighten the
screws on the front and rear Drum shaft clamper.
3) The Clamp plate base assembly should be pushed towards the rear of the Drum, as there is a
small play in mounting the assembly.
4) Using three wire harness lock bands of each about 100mm long, fix the position of the Ink sensor
relay wire harness to the Support frame and Rear support plate.
5) Make sure that the Ink sensor relay wire harness does not have any slack in the area indicated by
the dotted line on the photograph, and that the wire harness lock band tie area does not protrude
outside the bracket. This is to protect the wire harness.
Adjustments after Assembly
) Squeegee gap adjustment
2) Ink blocking plate position adjustment
3) Squeegee pressure balance adjustment
Support frame
Ink sensor relay wire harness
The wire should not have any slack in the
area indicated by red dotted line on the
photograph.
CZ80 / CV860 Rev. .0
RISO Inc. Technical Services & Support
The tie portion of the wire band should not go out of the metal plate.
Wire harness band
Drum support F
Rear frame
8 - 3
CHAPTER 8: PRINT DRUM
Drum support R
Rear frame
Drum JIG shaft
US.RISO.COM