Removal Of Paper Feed Tray Unit - Riso CZ180 Series Technical Manual

CHAPTER 4: FIRST PAPER FEED

2. Removal of Paper feed tray unit

Removal
) Lower the Paper feed tray all the way down, pull the Print drum out and switch OFF the machine
power.
2) Remove the Front cover. (M3x8 screws: 3 pcs)
3) Unplug the wire harness connector of the Paper detection sensor, cut off the wire band, and
gently pull the wire harness towards the Paper feed tray.
4) Remove the E-rings from the shaft of the Paper feed tray on both sides of the tray, and detach the
Paper feed tray unit from the shaft. (6mm E-ring; 2 pcs)
E-ring
RISO Inc. Technical Services & Support
Paper detection sensor wire harness
4 - 6 CZ80 / CV860 Rev. .0
US.RISO.COM