Table of Contents
Advertisement
c)
With the allen key provided remove the 4 allen bolts, loosening each one a small
amount at a time to prevent stressing the glass panel, then lift the glass frame clear.
d)
Refit the glass panel to the fire in reverse order, again tightening each Allen bolt a small
amount at a time to prevent stressing the glass panel.
e)
Fit the Allen key to the bracket which is situated at the bottom right hand corner of the
firebox, and advise the customer of the position of the Allen key.
4.6 CLEANING
WARNING – BEFORE ATTEMPTING TO CLEAN THE FIRE ENSURE THAT THE FIRE
HAS BEEN ALLOWED TO FULLY COOL
CLEANING THE STAINLESS AND PAINTED METAL PARTS.
The trim fitted to this appliance is stainless steel, and must only be cleaned with a clean,
damp cloth. Black painted metal parts should be gently cleaned with a damp cloth.
Abrasive cleaners, chemical cleaning agents or any type of polish must never be
used as damage to the paint may result.
CLEANING THE GLASS PANEL
To clean the glass panel, first ensure that the fire is cool, please note that the glass panel
will remain hot for a considerable period when the fire has been switched off.
To remove the glass panel, follow the instructions on page15 for removal and re-fitting.
The glass panel should be cleaned gently with a soft damp cloth and glass cleaner.
DO NOT UNDER ANY CIRCUMSTANCES ATTEMPT TO CLEAN THE GLASS PANEL
WHEN THE APPLIANCE IS RUNNING.
FOLLOWING CLEANING OF THE GLASS PANEL, ALWAYS ENSURE THAT THE
ALLEN KEY IS REMOVED FROM THE ALLEN BOLTS AND REPLACED INTO ITS
LOCATION AT THE BOTTOM LEFT HAND SIDE OF THE FIREBOX.
Finally, hand the Installation and Maintenance Instructions and the Users Instructions over
to the customer and explain the operation of the fire.
Supplied By www.heating spares.co Tel. 0161 620 6677
16
Advertisement
Table of Contents
