Spillage Monitoring System; Cleaning The Fuel-Bed - Flavel Linear Pebble FRDPU0MN User Instructions

SPILLAGE MONITORING SYSTEM

This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue.
If this system operates the fire will go out. If this occurs, leave the fire for at least
three minutes then follow the lighting procedure as described in the previous
section. In the event of repeated operation a CORGI registered gas installer
must be called to investigate and rectify the cause.
CLEANING - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool.The Linear trim and ashpan cover that was supplied with this fire is
manufactured from brushed stainless steel, and is best cleaned using a clean,
damp cloth regularly. The trim is best cleaned by removing it from the fire and
placing it face up on a flat surface. The trim is easily replaced by re-positioning it
on the fire and pushing it back onto the magnets. Black painted metal parts
should be gently cleaned with a damp cloth.
CLEANING THE LINEAR TRIM
Abrasive cleaners, chemical cleaning agents or any type of polish must
never be used as damage to the finish of the Linear trim & ashpan may
result.

CLEANING THE FUEL-BED

We do not recommend cleaning of the pebbles or fuelbed components as these
are fragile and damage may result.
None of these parts must be washed or exposed to any cleaning agents or
water.
Any damaged parts must be replaced by contacting your dealer or telephoning
BFM Europe Ltd. on the number stated on the rear cover of this book. The
pebbles must only be replaced with a complete and genuine replacement set and
the fire must never be run with the wrong number or damaged pebbles. The
fuel-bed must be carefully re-assembled as stated in the following section.
Note : Prior to replacing the oxypilot on this product due to
suspected failure of the component, please remove all debris that has
collected on the lint guard of the oxypilot itself.
5