Table of Contents
Advertisement
4.4
REMOVING THE OXY-PILOT ASSEMBLY
Note: Because this appliance is fitted with an atmosphere sensing 'Oxy-Pilot' it is
not possible to replace the thermocouple separately, because the thermocouple
position is factory set to a tight tolerance. Any replacement of parts on the pilot
requires a complete new pilot assembly.
a)
Remove the burner assembly as in section 4.1
b)
Unscrew and remove the thermocouple retaining nut from the end of the control tap
and disconnect the ignition lead from the pilot electrode.
c)
Unscrew pilot tube nut and disconnect pilot pipe.
d)
Unscrew and remove the two pozi-drive screws which secure the pilot assembly to
the burner. Remove the pilot.
e)
Reassemble in reverse order and carry out a gas tightness test.
4.5
REMOVING & REFITTING OF THE GLASS FRAME.
a)
Remove the 2 screws which hold the pilot shield in place.
b)
Remove the top infill panel by sliding it upwards out of the clips.
Supplied By www.heating spares.co Tel. 0161 620 6677
Top infill panel.
15
4 Allen key
fixing screws
Storage of
Allen key
Advertisement
Table of Contents
