Spillage Monitoring System; Cleaning The Fuel Bed - Flavel Calypso FNCN**SN Series User Instructions

REPLACING THE BATTERY (SLIDE CONTROL MODELS ONLY)
ENSURE THE FIRE IS COOL BEFORE REPLACING BATTERIES
Unscrew Battery retaining cap situated at the front right of the fire and remove
battery. Replace in the reverse order using a 1.5V AA Alkaline Battery. It is
important that only an alkaline battery is used, otherwise premature battery
failure and leakage may result.. Unscrew Battery retaining cap situated at the
front right of the fire and remove battery. Replace in the reverse order using a
1.5V AA Alkaline Battery. It is important that only an alkaline battery is used,
otherwise premature battery failure and leakage may result.

SPILLAGE MONITORING SYSTEM

This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue. If this system operates the fire will go out. If this occurs, leave
the fire for at least three minutes then follow the lighting procedure as described in
the previous section. In the event of repeated operation a CORGI registered
gas installer must be called to investigate and rectify the cause.
CLEANING - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool.
CLEANING THE TRIMS AND PAINTED METAL PARTS
Dependent upon the trim option chosen for use with this fire, there is a variety of
methods that can be chosen to clean the trim. If a Brass trim was supplied with
this fire this is plated brass and this trim must only be cleaned using a clean damp
cloth. Metal polishes must not be used on these trims. If a black trim was
chosen, then these should only be cleaned using a clean, damp cloth also. The
trim is best cleaned by removing it from the fire and placing it face up on a flat
surface. The fender that was supplied with the fire is laquered to protect the
finish and therefore must only be cleaned using a clean damp cloth.
Abrasive cleaners, chemical cleaning agents or any type of polish must
never be used as damage to the finish may result.

CLEANING THE FUEL BED

We do not recommend cleaning of coals or fuelbed components as these are
fragile and damage may result. None of these parts must be washed or
exposed to any cleaning agents or water. Any damaged parts must be
replaced by contacting your dealer or telephoning Flavel Fires on the number
stated on the rear cover of this book. Coals must only be replaced with a
complete and genuine replacement set and the fire must never be run with the
wrong number or damaged coals. The fuelbed must be carefully re-assembled as
stated in the following section.
8