Spillage Monitoring System; Cleaning The Fuel Bed - Flavel Caress Slimeline SC FNVC**SN User Instructions

Coal effect gas fire

Table of Contents

To turn the fire off, FULLY raise the control lever to the OFF position.

WARNING

If the fire goes out for any reason or is turned off and it is

necessary to relight the fire it is important to allow the fire to cool

for 3 minutes before attempting to re-light it.

SPILLAGE MONITORING SYSTEM

This appliance is fitted with a spillage monitoring system which shuts down the fire

if the evacuation of combustion products from the fire is affected by a partially or

fully blocked flue. If this system operates the fire will go out. If this occurs, leave

the fire for at least three minutes then follow the lighting procedure as described in

the previous section. In the event of repeated operation a CORGI registered

gas installer must be called to investigate and rectify the cause.

CLEANING - WARNING

Before attempting any cleaning operation ensure that the fire has been allowed to

fully cool.

CLEANING THE BRASS AND PAINTED METAL PARTS

Dependent upon the trim option chosen for use with this fire, there is a variety of

methods that can be chosen to clean the trim. The trim should only be cleaned

using a clean, damp cloth. The trim is best cleaned by removing it from the fire

and placing it face up on a flat surface, then wiping with a clean damp cloth. The

trim is easily replaced by

repositioning it on the fire and pushing it back onto the magnets.

The fender supplied with this fire is laquered to protect the finish and therefore

must only be cleaned using a clean damp cloth. Abrasive cleaners, chemical

cleaning agents or any type of polish must never be used as damage to the

finish may result.

We do not recommend cleaning of coals or fuelbed components as these are frag-

ile and damage may result. None of these parts must be washed or exposed

to any cleaning agents or water.

Any damaged parts must be replaced by contacting your dealer or telephoning

BFM Europe Ltd. on the number stated on the rear cover of this book. Coals must

only be replaced with a complete and genuine replacement set and the fire must

never be run with the wrong number or damaged coals. The fuelbed must be care-

fully re-assembled as stated in the following section.

Table of Contents