Furuno FCV-1200L Installation Manual page 52

9. Press [+] to select EXTERNAL, and then press [ ] or [ ] to close the dialog box.
10. Turn the [FUNCTION] switch to the EXIT position to quit.
Telesounder
The FCV-1200LM can only be connected to a telesounder on board a master ship and the
FCV-1200L to a telesounder on board a master ship or sister ship.
1. Turn on the power.
2. Turn the [FUNCTION] switch to the MENU position.
3. Press [ ] and [+] to select SYSTEM at the top of the screen.
4. Press [ ] to select E/S DRAFT SETTING, and then press [+] to open that menu.
5. Do the following for both the high and low frequencies, or whichever is installed.
a) Select XDCR CONNECT, and then press [+] to open the dialog box.
INTERNAL ETR TS/OTHER
b) Select TS / OTHER or INTERNAL referring to the table below, and then press [ ] or [ ] to
close the dialog box.
Equipment connected
Telesounder installed on sister ship
Telesounder installed on master ship
6. Press [ ] to select E/S SIG OUT, and then press [+] to open the dialog box.
OFF LF HF LF/HF
7. Select OFF, LF, HF, LF/HF referring to the table above.
8. Press [ ] or [ ] to close the dialog box.
9. Follow the procedure below to set up for telesounder installed on a master ship, or turn the
[FUNCTION] switch to the EXIT position to quit.
Do the following for telesounder installed on master ship
1. Turn the [FUNCTION] switch to the EXIT position.
2. Do the following for both the high and low frequencies, or whichever is installed.
a) Set the [MODE] switch in the LF, HF or DUAL (dual-frequency only) position.
b) Measure how many feet the transmission line is shifted, by using the VRM marker.
c) If the transmission line is shifted go to step 3, and if it has not shifted, go to step 6.
3. Turn the [FUNCTION] switch to the MENU position.
4. Press [ ] and [+] to show the SYSTEM menu.
3-10
E/S DRAFT SETTING menu item
XDCR CONNECT
INTERNAL
TS / OTHER
E/S SIG OUT
LF/HF
OFF