Furuno FCV-1200L Installation Manual page 39

Use a monitor cable (max. length 15 m) to connect a commercial monitor. A D-sub 15P
connector with three rows of pins is required for connection at the interface unit. The monitor
must satisfy the following requirements:
VGA type
Analog RGB, 0.7Vpp, positive polarity
TTL level H, V, negative polarity
Note 1: Two interface units may be connected.
Note 2: When connecting the Monitor Unit MC-101C or an interface unit to the terminal
DATA/VIDEO OUT its connector will touch the connector of DATA/VIDEO IN. To prevent this, cut
and remove the rubber covers and fixing metals from the connectors as below to attach them to
the interface unit.
Figure 2-9 Remover fixing metals and covers from connectors
Note 3: When connecting the interface unit to the Monitor Unit MU-101C or connecting two
interface units in parallel, cable lengths should be as below. Further, two cables (type 06S4078)
of 10 m in length cannot be used.
Connectors touch here.
Cut and
remove
covers.
of DATA/VIDEO IN and DATA/VIDEO OUT
Remove
fixing metals.
2-7