Furuno FCV-1200L Installation Manual page 38

Power cable
This video sounder is designed to be powered with 12-24 VDC power. To prevent power loss,
use power cable DPYCYS-2.0 (or equivalent) or equivalent. The armor should lie within the
connector case. Confirm polarity when connecting pins.
Lay armor in cable
Ground
The processor unit, monitor unit and interface unit should be grounded to prevent mutual
interference. Connect an earth plate or earth wire (interface unit) between unit and ship's
superstructure to ground.
CAUTION
Ground the equipment to
prevent electrical shock
and mutual interference.
Interface unit IF-8000
The Interface Unit IF-8000 is supplied standard with the FCV-1200LM and is optionally available
with the FCV-1200L.
DATA/VIDEO IN DATA/VIDEO OUT RGB OUT
Cable (06S4078)
from processor
unit
2-6
#1 pin (+)
#2 pin (-)
#3 pin
Figure 2-7 Fabrication of power cable
VGA
Monitor
Cable (06S4078)
from monitor unit
or interface
unit
Figure 2-8 Interface unit, rear view
yyyyyyyyyyy
yyyyyyyyyyy
yyyyyyyyyyy
Taping
yyyyyyyyyyy
yyyyyyyyyyy
Sheath
yyyyyyyyyyy yy
yyyyyyyyyyy yy yy
yyyyyyyyyyy
yyyyyyyyyyy
yyyyyyyyyyy
Core yyyyyyyyyyy
2
yyyyyyyyyyy
S = 3.5 mm
φ = 2.4 mm
CONT NMEA
Navigator
Earth terminal
(Ground to ship's
superstructure.)
GROUND TO
PREVENT MUTUAL
Cable (06S4079)
INTERFERENCE.
from control
unit
Shield
yy
yy yy
Armor
Vinyl Sheath