Wiring Standard Equipment - Furuno FCV-1200L Installation Manual

2.1

Wiring Standard Equipment

Transducer (FCV-1200L only)
Separate the transducer cable well away from power cables to prevent interference. Connect the
cable to the transducer connector at the rear of the processor unit. Fabricate the cable as below.
Note: For connection of dual-frequency transducer, use cable assy. NCS255AD-254P-L500
(option).
Echosounder interface (FCV-1200LM only)
The Echosounder Interface VI-1100A connects external equipment such as a color video
sounder, Transceiver Unit (ETR-5D/ETR-10D), Switch Box EX-7, etc. Attach connector
SRCN6A25-24P (supplied) to the signal cable assy. supplied with the Transceiver Unit.
Note 1: For the FCV-1200L, the EXIF board assy. (option) enables connection of external
equipment. Connector SRCN6A25-24P is optionally available.
Note 2: Telesounder may be connected to EXT-H or EXT-L.
(1) Solder connector terminals.
(2) Cover shield with shield foam where shield is to be clamped.
(3) Tighten clamp.
Figure 2-6 Fabrication of cable, connector for echosounder interface
Shield
Connector
Cable Clamp
Figure 2-5 Fabrication of transducer cable
Sheath
Shield
Solder connector terminals.
Sheath
Shield foam (conductive resin tape)
Shield Foam 71TS-10-1
Cable
Unfasten two screws.
CABLE
Pass connector case onto cable.
Clamp
Sheath
Shield foam
2-5