Furuno FCV-1200L Installation Manual page 26

3. Coat threads of upset screws (M6X16, 2 pcs.) used to fasten hanger to mounting base.
4. Fasten the hanger (or display unit) to the mounting base with two upset screws. (Use the
upper holes to tilt the display unit 20°; lower holes to tilt it 9°.)
Unibody monitor unit flush mount kit
Refer to the outline drawing at the back of this manual.
Unibody monitor unit flush mount kit: Type OP06-16, Code no. 006-556-300
Name
Mounting Fixture
Tapping Screws
Hex-head Screws
1. Make cutout in mounting location referring to page D-2A/D-2B.
2. Using four hex-head screws, fasten control and monitor units together with the mounting
fixture.
1-4
1
2
4
3
Figure 1-7 Hanger, rear view
HANGER
Upset Screw
Figure 1-8 Fastening hanger to mounting base
Type Code No.
06-021-1311 100-279-610
5X20 000-802-840
M4X12 000-882-040
Hanger (rear view)
1
2
4
3
se these holes to
tilt monitor unit 20˚.
MOUNTING
BASE
se these holes to
tilt monitor unit 9˚.
Qty Remarks
1
6
4