4. Press [ ] to select E/S DRAFT SETTING, and then press [+] to open that menu.
5. Do the following for both the high and low frequencies, or whichever is installed.
a) Select XDCR CONNECT, and then press [+] to open the dialog box.
INTERNAL
b) Select INTERNAL or ETR referring to the table below, and then press [ ] or [ ] to close the
dialog box.
Equipment connected
Transceiver Unit
External Video Sounder
c) If the transceiver or external video sounder is to be used when vessel is in dry dock, select
TX POWER and press [+] to open the dialog box.
MAX
1/2 1/4 1/8 1/16 MIN
d) Press [+] to select appropriate power, and then press [ ] or [ ] to close the dialog box.
3-8
DISP ALM TX/RX USER-1/2 SYSTEM
E/S DRAFT SETTING
<High Frequency>
XDCR CONNECT
TX POWER
DRAFT
FREQ CHOICE
<Low Frequency>
XDCR CONNECT : INTERNAL
TX POWER
DRAFT
FREQ CHOICE
E/S SIG OUT
KP SETTING
Select transducer connected.
[-/+]: Change set, [EXIT (knob)]: Exit
Figure 3-7 E/S DRAFT SETTING menu
ETR TS/OTHER
E/S DRAFT SETTING menu item
XDCR CONNECT
ETR
INTERNAL
:
INTERNAL
: MAX
: +0.0 ft (-15~+90)
: **kHz
: MAX
: +0.0 ft
(-15~+90)
: ***kHz
: OFF
: INTERNAL
E/S SIG OUT
OFF
LF, HF, LF/HF