Furuno FCV-1200L Installation Manual page 29

Blackbox type
Supply monitor and interconnection cable (D-sub connector, three rows of 15 pins, max. length
15 m) locally. The monitor connects to the interface unit, and should satisfy the specifications
shown below.
•
VGA type
•
Analog RGB, 0.7 Vpp, positive polarity
•
TLL level H, V, negative polarity
Control unit for blackbox type
The control unit comes in two types: portrait and landscape. The landscape-type control unit can
be installed on a desktop or flush mounted in a panel. For desktop, the control unit should be
fastened to the control unit mounting base (supplied with accessories). The portrait-type control
unit is designed for flush mounting. For flush mount, the control unit should be fastened to the
mounting fixture (supplied with accessories).
For mounting dimensions see the outline drawing at the back of this manual.
1. Fasten the control unit mounting base to the mounting location with two 5X20 tapping
screws.
2. Fasten the control unit to the control unit bracket with two M4X12 hex-head screws.
3. Inserting screwdriver through holes at the top of the control unit mounting base, loosely
screw in two M4X12 hex-head screws.
Cable
entrance
Tapping screw
Control unit
(M5X20)
bracket
Cable can be led in
through here.
Figure 1-12 How to mount the control unit for blackbox type
4. Set the control unit to the control unit mounting base and fasten hex-head screws inserted at
step 3.
5. Set cosmetic plugs (2 pcs.) to the holes at the top of the control unit mounting base.
Control unit
mounting base
Control unit
bracket
Control unit
(rear)
: Fix with hex-head screws.
Fasten control unit
Cable
bracket from here.
Set to screws loosely
fastened at step 3.
1-7