Furuno FCV-1200L Installation Manual page 41

EXIF board assy.
The EXIF board assy. (type OP02-81, code no. 000-012-463), installed inside the processor unit
CV-1203, is necessary when connecting a telesounder (on sister ship and master ship),
transceiver or other video sounder to the FCV-1200L. Below are the contents of the EXIF board
assy. kit. For connection cable use type S-02-6-10 (24P, 10 m, Code No. 002-962-030).
Name
EXIF Assy.
Pan Head Screw
SRCN Connector
1. Remove the cover of the processor unit by unfastening 13 screws (M4X8).
2. Unfasten two screws to remove the dummy plate. (The screws and plate may be discarded.)
3. Unfasten screw marked with ! in the figure below. (The screw may be discarded.)
4. Fasten the EXIF board assy. to the chassis with three screws (M4X10, supplied).
5. Connect the EXIF Assy. between J1 on the pcb 02P6278 and J7 on the MAIN board.
6. Set the DIP switches on the circuit board 02P6279, referring to page 3-23.
7. Close the cover.
Type
OP02-81 001-413-440
M4X10 000-881-446
SRCN6A25-24P 000-508-676
Dummy plate
Figure 2-12 Processor unit CV-1203, rear view
POWER
SECTION
Screw
(M4X10)
Figure 2-13 Processor unit CV-1203, left side view
Code No. Qty
1
3
2
Unfasten 13 screws to remove cover.
Left, right, top: 6 (2 screws each side)
Heat sink: 7 screws
Unfasten two screws to remove dummy plate.
*Screw
(M4X10)
J7
MAIN
Board
J1
EXIF Board
Assy.
*- Fasten screw here.
Remarks
2-9