Otto Bock A200 Instructions For Use Manual page 117

NOTICE
Risk of battery damage. Setting the characteristic curve
incorrectly can result in permanent damage to the battery.
When handling the battery charger, the following safety in-
structions must be observed:
„ D Always place the rubber feet of the battery charger
on a level surface.
„ Protect the battery charger from direct sunlight to prevent
the charger from getting any warmer than it already is.
„ The location where the battery charger is installed must
be dry and well ventilated. Avoid letting dust and dirt
enter the battery charger. It can impair the functionality
of the battery charger.
„ To clean the charger, use a dry piece of cloth.
To charge the batteries, proceed as follows:
1. Turn off the control unit on the power wheelchair.
2. Connect the plug of the battery charger to the charging
receptacle on the control panel of the power wheelchair
(see Fig. 20).
A200
3. Connect the battery charger to a wall outlet. The batter-
ies will start charging automatically, and the current
battery capacity is indicated on the LEDs on the battery
charger.
4. When the charging process is complete: Disconnect the
battery charger from the mains supply.
5. Turn on the control unit; the power wheelchair is now
ready for operation.
Please see the instructions for use supplied with the battery
charger for further details on use and on the LED indicators.
Operation
Ottobock 117
|