Wall Mounting - Adesys Octalarm-IP Manual

Wall mounting

Proceed as follows if the Octalarm-IP is to be mounted on a wall:
• The rear of the Octalarm casing has two screw holes. One of these (1, top right,
viewed from the front) can only be accessed from the rear, the second (2, below left,
viewed from the front) can be accessed from the front.
• Drill a hole and screw a screw into the wall at the place where the top, right-hand side
(where the screw hole is located) of the Octalarm is to be hung.
• Hang the alarm dialer on the screw that's already in the wall, then hold it vertically and
mark the screw hole at the bottom left.
• Remove the alarm dialer and drill a new hole.
• Hang the Octalarm-IP on the first screw again, hold it vertical and screw in the second
screw.
Octalarm-IP 100104E 43