Adesys Octalarm-IP Manual page 17

7 Info key
The Info key gives access to the alarm
dialer's basic data. Among other things
you will find the dialer's identification data
such as the serial number, the software
version and the IP number. The last is
particularly important when you want to
program the alarm dialer from a
computer. You can also use the IP
number to check if the alarm dialer has an
internet connection. If no IP number is
displayed you will not be able to access
the alarm dialer via the ethernet and you
also won't be able to use the ACC
facilities. See page 32. You can also
access the logbook from this page where
you will find an overview of the alarm
report that have been made.
8 Set key
The Set key is used to activate and
deactivate inputs, turn off alarm
forwarding temporarily or permanently,
turn local alarms on or off and to indicate
whether or not an alarm report should be
made when there is a malfunction in the
mains voltage or the ACC system.
9 Alarm forwarding and buzzer
These two LEDs indicate if the forwarding
for the alarms and the alarm buzzer are
switched on.
10 System malfunctions
These two LEDs indicate if reports of the
mains voltage failure and system
malfunctions that arise are being
forwarded.
Octalarm-IP 100104E
11 Inputs status
Depending on which type of alarm dialer
you have there will be two rows with 1, 2,
4, 8 or 12 LEDs. The row of red LEDs on
the left give the status of the input in
question. The LED is off when it is idle. If
the status changes the LED will flash for
the delay time that has been set. If the
input is active the red LED will stay on.
The green LEDs in the row on the right
indicates if status changes to the input in
question are being forwarded. When the
LED in question is out, nothing is being
forwarded, while the red LED in the row
on the left can still indicate that there is a
change to the input status.
12 Microphone
Models from the Octalarm A-range have a
microphone behind the grill on the left-
hand side of the front panel for recording
text when necessary for giving an alarm
or for the voice response system. Models
from the B-range do not allow recording
messages.
13 Display
All information that is required for
operating and programming the Octalarm-
IP appears on the central display. The
alarm dialer can be set more comfortably
and with a better understanding if this is
done via a computer that is connected to
the Octalarm-IP via the ethernet. No extra
software is needed to do this. Use can
use a standard web browser such as
Microsoft Internet Explorer
®
Firefox for this.
®
or Mozilla
13