Step 4: Compiling A Call List - Adesys Octalarm-IP Manual

Step 4: Compiling a Call List

04.Call Lists
You will be offered the following menus when compiling up Call Lists:
name
priority
report to
repeat if not accepted
repeat delay
1 First choose a Call List from the list or use the F3 Options function key to make a new Call
List or to remove one.
2 Use the F3 Options function key to add or remove receivers from the Telephone Book.
3 The alarm dialer has the standard option -- All numbers – for use when compiling a Call List.
The alarm dialer uses all the receivers that are present in the memory for reporting any
alarms. This is to ensure that alarms are always answered somewhere even if the alarm dialer
has only been partly programmed.
To imitate this the alarm dialer is also programmed with a Standard Action List and a Standard
Call List that uses this option. So with a new alarm dialer that has come directly from the
supplier, it is theoretically sufficient to enter one or more telephone numbers without any
further programming and still have alarm reports processed completely and correctly.
4 It is possible to include a receiver a number of times in a Call List. This make it possible to
alternate calls between receivers or have repeats for a specific receiver for example. So,
based on the example on page 33, you could have two calls to John and then one to Sophie.
Octalarm-IP 100104E
1
very high
high
average
low
very low
options (F3)
2 + 3 + 4
none
1 minute
2 minutes
5 minutes
10 minutes
priority
add
times
repeat delay
23