Quick Start Mode For Fast, Easy Set Up - Adesys Octalarm-IP Manual

Quick start mode for fast, easy set up

After logging in to the alarm there is the option of Quick Start or Complete. Quick Start directs
you to a simplified set up procedure where the manufacturer's settings are used for the menus
that aren't displayed. In such situations you will only see the following menus:
01.ACC
02.General
03.Telephone Book
03.Inputs
99.Return to
manufacturer's
settings
Only setting up these menus creates an alarm system in which all inputs are linked to a
standard action list and a standard call list.
All inputs
If an alarm is activated the standard action list results in the following actions:
• start the Octalarm-IP's bell
• turn on the external bell and flashing/rotating light
• start the standard call list without delay
• The standard Call List results in the following call actions:
• calls the first person in the telephone book two times maximum and waits for reset
• goes to idle after rest with automatic repetition after 1 hour
• if there is no reset, it calls the second person two times maximum
• goes to idle after rest with automatic repetition after 1 hour
Octalarm-IP 100104E
This can be used to connect the Octalarm to ACC. (see
page 19 and 18)
This is where settings relating to language and time are
entered. (see page 20). In this menu you can also turn
off the use of pincodes.
This is where the telephone numbers for Installers,
Administrators, Assistant Administrators and Service
Personnel who have to deal with alarm reports are
entered, Only reset. (see page 21)
This is where inputs are configured, including settings
such as open in idle (NO) or closed in idle (NC) and/or
the contacts are connected directly or via Sensorbus.
(see page 26 and 45)
The alarm can also be reset to the manufacturer's
settings in Quick Start mode. (see page 14)
Action
list
All telephone
Call list
numbers
15