6- Complete Procedure / Step Plan - Adesys Octalarm-IP Manual

6- Complete procedure / step plan

The following steps generally have to be gone through in order to fully program the Octalarm-
IP:
Step 1 Connect the alarm dialer to the ACC, if the alarm dialer uses this facility via the internet
Step 2 Select the language for the menus and enter the location name. If the alarm dialer is
connected to the ACC the date and time will be set automatically.
Step 3 Enter the alarm receivers, these are the people that have to respond to malfunctions,
in the Telephone Book. Here, they are each given a name, a call number and an authorisation
Do not forget to change the pincodes in the manufacturer's settings to those of your
own choice.
Step 4 Make Call Lists. Receivers can be called out depending on their function.
Step 5 Make Action Lists: determine the nature and urgency of the alarm reports and,
depending on this, the action that has to be taken
Step 6 Set the Input properties and use clear alarm names when doing this.
Step 7 Set which external equipment is connected for local alarms.
Step 8 Enter the actions that the alarm dialer has to take when there are system malfunctions.
Step 9 Enter the circumstances under which local alarms have to be given.
Step 10 Specify how the alarm dialer has to deal with incoming and outgoing telephone lines.
Step 11 When the alarm dialer has a number of line interfaces (PSTN, GSM), it can be
specified which type of message should use which line interface.
Octalarm-IP 100104E 17