kozy heat 55801 Duluth Installation & Operating Manual page 21

8. Push in the control knob all the way and hold in. Press the square piezo igniter button (B).
light with two or three pushes on the igniter. Hold the knob in for about one (1) minute after the pilot is lit. Release
knob and it will pop back out. Pilot should remain lit. If it goes out, repeat steps #4 through #8.
*
If knob does not pop out when released, stop and immediately call your service technician or gas supplier.
* If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician
or gas supplier.
9. Turn gas control knob counterclockwise
10. The burner can now be turned 'ON' or lit by pressing the ON/OFF rocker switch (C), located on the lower right frame
on the fireplace, to the 'ON' position
11. Close the panel.
12. NOTE: When the fireplace is initially lit, condensation will appear on the glass, this is normal in all gas fireplaces,
and will disappear in one to three minutes.
TO TURN THE BURNER OFF:
To turn the burner 'OFF', press the ON/OFF rocker switch to the 'OFF' position, flip 'off' the wall switch or adjust the
setting on the thermostat or remote control. NOTE: The pilot will stay lit.
TO TURN THE PILOT OFF:
1. Lift up the panel under the fireplace to access the gas valve and controls. Push the panel 'in' slightly and it will stay
in position.
2. Set the thermostat to the lowest setting (if installed).
3. Turn off all electric power to the appliance if service is to be performed.
4. Push in and turn the control knob clockwise
WARNING: This control valve has an interlock device.
After turning off the pilot, it cannot be relit until the thermocouple
has cooled, (approximately 60 seconds).
Figure 16
KEEP BURNER & CONTROL COMPARTMENT CLEAN. SEE INSTALLATION AND OPERATING INSTRUCTIONS ACCOMPANYING APPLIANCE.
AN ODOR WILL OCCUR DURING THE FIRST FEW HOURS OF BURNING. THIS IS THE PAINT CURING AND
SUBSTANCES USED IN THE MANUFACTURING PROCESS.
INSTALLED) OFF DURING THIS PERIOD AS IT WILL SPEED UP THE PAINT CURING PROCESS.
IMPORTANT: DO NOT BURN THIS FIREPLACE WITHOUT THE GLASS ENCLOSURE PROPERLY IN PLACE.
NOTE: Children and adults should be alerted to the hazards of high surface temperatures and should stay away
to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same room
as the appliance.
Clothing or other flammable material should not be placed on or near the appliance.
NOTE: THIS FIREPLACE MAY PRODUCE NOISES OF VARYING DEGREE AS IT HEATS AND COOLS TO DUE METAL
EXPANSION AND CONTRACTION. THIS IS NORMAL AND DOES NOT AFFECT THE PERFORMANCE OR
LONGEVITY OF THE FIREPLACE.
to the "ON" position.
OR
by setting the thermostat or remote control to the desired setting.
INITIAL BURN PERIOD
**MAKE SURE THE HOMEOWNER IS AWARE OF THIS**
to the 'OFF' position. DO NOT FORCE.
IT IS RECOMMENDED TO LEAVE THE FAN (IF
Page 19
The pilot will generally