kozy heat 55801 Duluth Installation & Operating Manual page 11

Figure 7D
7. Mount the speed control box onto the left side of
the gas valve control dashboard by aligning the
holes in the box to the holes in the dashboard and
secure with the (2) black phillips head screws, one
in each of the mounting holes. Refer to Figure 7D
above.
9. Plug the 3-prong plug on the fan cord into the left side of the speed control box (Figure 7D).
10. Plug the 3-prong plug on the cord attached to the speed control box into a properly grounded three-prong
receptacle.
11. Turn the speed control counter-clockwise until it 'clicks'. This is the 'OFF' position.
12. Turn the speed control 'ON' by turning the knob clock-wise past the 'click' - this is the highest setting.
THERMOSTATIC CONTROL SWITCH POSITION: Prior to adjusting the temperature control switch, unplug the 3-prong plug on the fan cord
from the receptacle. Adjust the position of the temperature control switch to a warmer location under the firebox to turn the fan 'ON' sooner
or move it to a cooler location under the firebox to turn the fan 'ON' later. The fan will turn on when the sensor in the temperature control
o
switch reaches 110 F and will turn 'OFF' when the sensors reach 90
receptacle.
NOTE: The fan will not operate unless the speed control has been turned 'ON' and sufficient heat has been applied to the thermostatic control
switch. The fan will turn 'ON' and 'OFF' automatically when the fireplace heats and cools. Adjust fan to desired speed while it is running.
This appliance must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current NFPA 70 - National
Electrical Code.or the Canadian Electrical Code, CSA C22.1.
Fan wiring diagram
8. Place the temperature control switch (magnet
attached) onto the bottom of the firebox as close
to the center as possible. Refer to Figure 7E above.
o
F. After adjustment, plug the 3-prong plug on the fan cord into the
Page 9
Figure 7E