Table of Contents
Advertisement
If there is no startup display after one minute when you turn on
No Startup
Display on
your workstation, which contains a graphics options card, see the
possible causes in Table 13–5.
Workstation
Table 13–5 Missing Startup Display
Possible Cause
Monitor is not plugged in.
Monitor is not turned on.
Monitor brightness and
contrast controls are too dark
to see the screen display.
Monitor cable or video cable
is not connected.
Monitor fuse is blown.
Wall socket may not be
operative.
Console switch is in the
wrong position
Startup Problems
Corrective Action
Plug the monitor power cord into a
power outlet of the correct voltage.
Turn on the monitor. Monitor power
LED should be on.
Adjust the monitor brightness and
contrast controls. Verify that the
monitor power switch is on.
Check that the monitor cable and video
cable are plugged in at both ends. (See
Chapter 3 for installation instructions.)
See the monitor guide for fuse
replacement instructions.
Try a different wall socket, or try an
electrical device that you know works
in the wall socket.
Check that the switch is in the correct
position.
Identifying a Problem 13–9
Advertisement
Table of Contents
