Setting And Verifying The Network Connection - DEC 3000 800 Owner's Manual

Setting and Verifying the Network Connection

After completing the hardware network connections to your
After Cable
system, you must complete the following tasks:
Connections
1. Set the network connection type.
2. Verify the network connection.
Two Network There are two network settings recognized by your system–
Settings THICK for AUI Ethernet or 10BASE2 (ThinWire) Ethernet, and
TENBT for 10BASE-T Ethernet. The default setting is THICK.
See Table 5–5 for the network setting you should use.
Table 5–5 Network Settings
For this network...
AUI Ethernet
10BASE2 (ThinWire)
Ethernet
10BASE-T Ethernet
Setting and Verifying the Network Connection
Use this network setting...
THICK
THICK
TENBT
Connecting the System to a Network 5–11