®
Gilbarco
Terminal Default Settings
This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for a
Gilbarco terminal, then power cycle the host. This bar code sets the baud rate to 2400 bps and the data format to 7 data
bits, even parity, 2 stop bits. It also adds a carriage return (CR) suffix and programs the following prefixes for each symbol-
ogy:
Honeywell Bioptic Aux Port Configuration
This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for a
Honeywell bioptic scanner auxiliary port configuration, then power cycle the host. This bar code sets the baud rate to
38400 bps and the data format to 8 data bits, no parity, 1 stop bit.
Datalogic™ Magellan
This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for a
Datalogic Magellan auxiliary port configuration, then power cycle the host. This bar code sets the baud rate to 9600 bps
and the data format to 8 data bits, no parity, 1 stop bit.
2 - 16
Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Gilbarco Settings
Honeywell Bioptic Settings
®
Aux Port Configuration
Datalogic Magellan Settings
Prefix
A
E0
FF
F
ReM On