Scanner Idle Alarm; Scanner Power Time-Out Timer - Honeywell Voyager 1602g User Manual

Scanner Idle Alarm

When the scanner is idle for over 1 hour, you can set it to beep every minute until the trigger is pressed. Default = Scanner Idle
Alarm Off.
Scanner Idle Alarm On

Scanner Power Time-Out Timer

When there is no activity within a specified time period, the scanner enters low power mode. Scan the appropriate scanner
power time-out bar code to change the time-out duration (in seconds).
Note: Scanning zero (0) is the equivalent of setting no time-out.
If there are no scan button presses during the timer interval, the scanner goes into power down mode. Whenever the scan but-
ton is pressed, the timer is reset. The scanner will not go into power down mode when the battery is charging. Default = 3600
seconds.
0 seconds
400 seconds
* 3600 seconds
* Scanner Idle Alarm Off
200 seconds
900 seconds
7200 seconds
3 - 9