Charging With A Pc; Battery Charge Indicator; Pairing The Scanner With Bluetooth Devices - Honeywell Voyager 1602g User Manual

Charging with a PC

Charging your scanner battery through the USB port of a computer will take longer than charging with an electrical outlet.
Connect the mini-USB connector to the scanner and the USB connector to the computer, as shown below.
Note: The mini-USB connector is only used for charging the scanner. If using a scanner in corded mode, it can also be
used to configure the device via EZConfig (see page

Battery Charge Indicator

When the battery is charging, the small LED at the top left of the scanner flashes orange. When the battery is fully
charged, this LED is solid green. Refer to
3-6) for the complete list of LED indications.
To use your scanner with a Honeywell Access Point (AP01-XXXBT), refer to
Scanner to an Access Point, page 3-13.

Pairing the Scanner with Bluetooth Devices

The scanner can be paired with Bluetooth devices such as personal computers, laptops, and tablets.
1 - 2
9-3 for further information).
Scan LED Sequences and Meaning (page 3-6) and Low Battery Indicator
Host ACK Responses, page 3-22 or
(page
Linking the