Datalogic™ Magellan
Configuration
Scan the following Plug and Play code to program the scanner for a Data-
logic Magellan bioptic scanner auxiliary port configuration. This bar code
sets the baud rate to 9600 bps and the data format to 8 data bits, no parity,
1 stop bit.
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on
programming code above.
NCR Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for an NCR
bioptic scanner auxiliary port configuration. The communication should be
set at 9600bps baud rate, 7 data bit data format, even parity and 1 stop bit.
The following prefixes are programmed for each symbology:
Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on
programming code above.
2 - 6
©
Bioptic Aux Port
Datalogic Magellan Bioptic Settings
Prefix
A
E0
FF
F
NCR Bioptic Settings
page 1-6
Symbology
Code 39
Interleaved 2 of 5
All other bar
codes
page 1-6
first, then scan the
Prefix
B1
B2
B3
first, then scan the