Step 4 - Turning On Your Monitor; Step 5 - Testing And Getting To Know Your Monitor - Angelcare AC701 Owner's Manual

STEP 4 - TURNING ON YOUR MONITOR

2
1
When the Parent Unit is turned
ON and the Nursery Unit is OFF,
the Parent Unit will be searching
for connection with the Nursery
Unit. The Connection icon will scan
as the following cycle.
IMPORTANT ICONS
Temperature icon:
Indicates room temperature
Battery Level icon:
Indicates battery level
Empty
1/3 Full
2/3 Full
Full
Settings Icons: Access to settings
VOX icon: Indicates Vox function
is active (Voice activation)
ECO icon: Indicates ECO function
is active
Temperature Alarm icon: Indicates
Temperature Alarm is active
14
1) Press the Parent Unit ON/OFF button
to open and display normal mode.
2) Push and hold the Nursery Unit
left 'wing' button for 2 seconds.
The LCD monitor has 30 seconds
timeout to go to power saving
mode (dimmer illumination).
Press any keys to wake up.
If there is a lost connection
between the 2 units
(refer to troubleshooting):
• The Out-of-Range icon
will appear on the screen and
the Parent Unit will beep.
Sound icon: Indicates sound
is active
Sensor Pad icon: Indicates
the Movement Sensor is active
Pendulum icon: Indicates
the 'TIC' function is active
Level Bar: Indicates sound level
from Nursery Unit.
Connection icon: Indicates
the connection quality between
the Parent Unit and Nursery Unit.
Good connection
Fair connection
Poor connection
Out-of-Range

STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR

The Angelcare ® monitor can be used with the pre-program factory settings
or you can also customize your settings to your preference.
NOTE: All changes
and adjustments made
in the settings mode will
not be activated unless
you confirm them by
pressing the Return icon.
A long beep will confirm
your modification.
5.1 - SENSOR PAD
TO ACTIVATE THE SENSOR PAD:
1
TO TEST THE SENSOR PAD:
1 2
MOVEMENT ALARM
• Alarm activates when no movement is detected by Sensor Pad for 20 seconds.
• Both the Parent Unit and Nursery Unit speakers will emit loud warning sound.
• Movement Alarm icon will show on the LCD screen.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust the Sensor Pad sensitivity level.
IMPORTANT
When in settings mode, sound
transmission between Parent and
Nursery Units will be temporarily
deactivated. ONLY the movement
alarm will remain active
(if function is activated).
1) Press Sensor Pad icon to activate
or deactivate movement mode.
ON OFF
When the movement mode is OFF
the 'TIC' mode is automatically set OFF.
This allows you to detect the baby's
sounds ONLY.
1) Move your hand lightly on the mattress.
2) Remove your hand from the mattress.
After 15 seconds you will hear a
'TIC' pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
3) Repeat by moving your hand lightly
in all four corners of the mattress.
Ensure the Nursery Unit Movement
Indicator is still flashing.
15