Turning On Your Monitor; Nursery Unit; Parent Unit - Angelcare AC327 Owner's Manual

4- TURNING ON YOUR MONITOR

NURSERY UNIT

PAUSING AND RESTARTING THE
SENSOR PAD
• Allows you to pause the Sensor Pad if you
remove baby from the crib, e.g. for feeding or
comforting. Ensure to un-pause the Sensor
Pad before putting baby in the crib
TEST THE SENSOR PAD (ON MODEL AC327 AND AC337)
1. Sources of vibration & movement other than your baby's can be detected by the Sensor Pad and
interfere with the performance of your Angelcare monitor. The alarm will not sound if it detects
movement other than your baby's
2. There are 4 sensitivity settings. The unit is set at level 2 (default) and can be adjusted accordingly
3. The Sensor Pad will detect false movements if you are touching the crib
4. The monitor will produce a Pre-alarm single beep tone designed to stir baby if no movement has
been detected for 15 seconds. If no further movement is detected, the main alarm will sound at
20 seconds
SENSOR PAD FOUR CORNER TEST
1. Place the Sensor Pad at the centre of baby's sleeping area and put the mattress back in place
2. Switch ON both Nursery & Parent Units
3. Place your hand in a corner of the mattress and keep it there for 20 seconds
• If the alarm sounds, even after placing your hand in any of the corners, adjust
the sensitivity higher by a single level and repeat this test
• If the movement alarm does not sound, continue the below:
- Step away from the crib, after 20 seconds an alarm will sound from the
Nursery and Parent Unit
4. Place your hand back onto the mattress in a different corner, the alarm will
cease as movement is detected
• Repeat in the remaining corners
• If the alarm does not sound when you step away from the crib, lower sensitivity down a single level
and repeat this test. If the problem persists, check for other sources of vibrations in the nursery
CFO_ANGE_Manuel_AC327_NA.indd 7

PARENT UNIT

NURSERY UNIT
Note:
• Your Nursery Unit and Parent
Unit come pre-paired
• Each time you power ON your
Nursery Unit, the internal
thermometer will need to
calibrate to ensure accuracy.
This automatic process
will take approximately
30 minutes
PARENT UNIT
2018-10-31 10:45 AM
E
N
7