Setting Up The Nursery Unit; Turning On Your Monitor; Parent Unit - Angelcare AC127 Owner's Manual

IMPORTANT
• If your cot does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hardboard between the cot base and the Sensor Pad, to ensure correct
operation. The hardboard support must measure at least 30 x 30 cm
(12" x 12") and 6 mm (1/4") thick. This hardboard support must be
larger than the Sensor Pad surface area
• The Sensor Pad functions with standard cot sprung and foam
mattresses and not memory foam (partial or full), hollow frame
construction mattresses and water beds. Please consult Angelcare if
unsure of mattress compatibility. The hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby's movements even when the baby
is at the edges of the cot

3- SETTING UP THE NURSERY UNIT

Sensor Pad

4- TURNING ON YOUR MONITOR

6
Unit and Adaptor cord

PARENT UNIT

Note:
• The alkaline batteries (not included)
are a back-up power supply in case
of power outage
Place the Nursery
at least 1 metre
from the cot
NURSERY UNIT