Spare Parts Shortlist / Wiring Diagram - Flavel FVPC**MN Installation, Maintenance & User Instructions

4.5.3 Disconnect the solenoid plug from the harness.
4.5.4 Unscrew the solenoid pipe from the retaining brackets.
4.5.5 Remove solenoid from pipe and refit new solenoid.
PARTS SHORTLIST / WIRING DIAGRAM (FIG. 35)
Replacement of any other parts must be carried out by a competent person such
as a GAS SAFE registered gas installer. The part numbers of the main
replaceable parts are as follows, these are available from your local stockist,
whose details may be found on the BFM Europe website, address as shown
on the rear cover.
Fuelbed base (coal models)
Fuelbed base (pebble models)
Fuelbed front rail (pebble models)
Replacement pebble set
Fuelbed front ceramics rails (coal models)
Replacement coal set & ceramics
Piezo Igniter
Ignition Wire
Manual Gas Valve (NG)
Pressure Switch
Solenoid Valve
Fan Motor
Fan Proving Unit
2.5 metre standard wiring loom
6.0 meter wiring loom (for use with additional flue duct)
830mm flue length (for use with additional flue duct)
100mm x 100mm duct connector (for use with additional flue duct)
100mm x 100mm 45 degree bend (for use with additional flue duct)
100mm x 100mm 90 degree bend (for use with additional flue duct)
Fig. 35
Important Note : Should the electric mains supply cable require replacing,
this must only be carried out by a BFM service agent or other suitably
qualified person.
33
B-56320
B-77260
B-58140
B-77250
B-56330
B-56960
B-1320
B-39030
B-102880
CV-103507
CV-104303
CV-103330
CV-103505
CV-H47
CV-H79
CV-3350
CV-3351
CV-3359
CV-3357