Table of Contents
Advertisement
5.2
LIGHTING THE APPLIANCE (ALL MODELS)
5.2.1
Turn on the gas isolation tap.
5.2.2
Depress the "ON / OFF" switch on the switch control panel,
located at the left hand side of the fire (when viewed from the front) to
the "ON" position. Press the momentary switch, the fan unit will
operate, and when the air pressure switch (located inside the fan unit)
detects sufficient air flow within the flue, an audible click will be heard
and the gas solenoid valve will open.
5.2.3
Depress the control knob and turn anti-clockwise to the position
marked ignition / low rate. Hold in the control knob for a few seconds to
purge the pipe work.
5.2.4
Continue to hold-in the control knob and press the igniter button. If the
burner does not light, continue to press the igniter button until ignition
occurs. Continue to hold the control knob for a minimum of 10 seconds
to allow the thermocouple to heat up, if the burner goes out when the
control knob is released, repeat the lighting sequence.
5.2.5
Turn the control knob in the anti-clockwise direction to the high position
and the gas rate will increase to high rate (6.9 kW)
5.2.6
Turn the control knob clockwise to the low position and the gas input
will be reduced to the minimum setting (4.2 kW)
5.2.7
Slightly depress the control knob and turn to the off position, the burner
will now be extinguished.
WARNING : If the fire goes out for any reason or is turned off and it
is necessary to re-light the fire it is important to allow the
fire to cool for 3 minutes before attempting to re-light it.
37
Advertisement
Table of Contents
