Table of Contents
Advertisement
5.4.5
Select pebbles K, L & M and arrange along the rear of the
fuelbed, using the ribs in the rear of the fuelbed as a guide for
placement. (See fig. 5 below)
Fig. 5
Pebble J
Pebble K
5.4.6
Select the two small pebbles (J & N) and position to fill the gaps at each
end of the third row of pebbles, as shown above in Fig. 5.
Warning : Use only the pebbles supplied with the fire. When replacing the
pebbles remove the old pebbles and discard them. Fit a complete set of pebbles
of the correct type. Do not fit additional pebbles or any pebbles other than a
genuine replacement set.
To ensure that the release of fibres from these R.C.F (Refractory Ceramic
Fibre) articles is kept to a minimum, during installation and servicing we
recommend that you use a HEPA filtered vacuum to remove any dust
accumulated in and around the appliance before and after working on the
appliance. When replacing these articles we recommend that the replaced
items are not broken up, but are sealed within heavy duty polythene bags,
clearly labelled as "RCF waste". RCF waste is classed as a "stable", non
reactive hazardous waste and may be disposed of at a landfill licensed to
accept such waste Protective clothing is not required when handling these
articles, but we recommend you follow the normal hygiene rules of not
smoking, eating or drinking in the work area, and always wash your hands
before eating or drinking.
REMOVAL / RE-FITTING OF THE TRIM / FASCIA
The trim is secured onto the firebox flange by the use of magnets. The fret, where
applicable should be placed upto the fire with the ashpan and centralised
41
Pebble N
Pebble M
Pebble L
Advertisement
Table of Contents
