Table of Contents
Advertisement
FRET INFORMATION
To enable Customers to choose their own style of fret these Quasar models are
now available without frets. In order to maintain the efficient and safe
operation of the fire it is important that any fret which is used must comply with the
following dimensions. (figure 34). It is important to clean a fret in accordance with
the instructions provided by your retailer as these vary depending on the surface
finish of the fret.
Fig. 34
Minimum Total Open
Area of Fret 110cm2
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a GAS
SAFE registered gas installer. The part numbers of the replaceable parts are as
follows, these are available from BFM Europe who may be contacted at the
address shown on the rear cover.
Complete coal / ceramic set
Coal fuelbed base
Coal fuelbed front rails (pair)
Complete pebble / ceramic set
Pebble fuelbed base
Pebble fuelbed front rail
Replacement pebble set
RC gas control valve
RC handset
Piezo igniter
Ignition wire manual control models
Ignition wires slide control models
Ignition wire remote models
Manual gas valve
Slide gas valve
Manual control pilot
Slide control pilot
Remote pilot
Two Air Slots each of
Minimum Area 19cm2
42
Maximum
Height
210mm
B-139350
B-56320
B-56330
B-77250
B-77260
B-58140
B-77250
B-160780
B-168960
B-1320
B-39030
B-50380
B-34690
SP-10680
B-40980
B-38930
B-49710
B-170240
Advertisement
Table of Contents
