Table of Contents
Advertisement
5.3 CLEANING - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool. The trims are easily replaced by re-positioning them on the fire and
pushing it back onto the magnets. Black painted metal parts should be gently
cleaned with a damp cloth.
5.3.1
CLEANING THE LINEAR TRIM
Use only a damp cloth to clean the Linear trim. Abrasive cleaners,
chemical cleaning agents or any type of polish must never be used as
damage to the finish of the Contemporary trim & ashpan may result.
5.3.2
CLEANING THE BRASS AND PAINTED METAL PARTS
Dependent upon the trim option chosen for use with this fire, there is a variety of
methods that can be chosen to clean the trim. If a Brass trim was supplied with
this fire this is plated brass and this trim must only be cleaned using a clean damp
cloth. Metal polishes must not be used on these trims. If a chrome or black trim
was supplied, then these should only be cleaned using a clean, damp cloth also.
The trim is best cleaned by removing it from the fire and placing it face up on a flat
surface. The trim is easily replaced by repositioning it on the fire and pushing it
back onto the magnets.
Abrasive cleaners, chemical cleaning agents or any type of polish must
never be used as damage to the finish may result.
5.3.3
CLEANING THE FUEL-BED
We do not recommend cleaning of the pebbles / coals or fuelbed components as
these are fragile and damage may result.
None of these parts must be washed or exposed to any cleaning agents or
water.
Any damaged parts must be replaced by contacting your dealer or telephoning
BFM Europe Ltd. on the number stated on the rear cover of this book. The
pebbles or coals (dependent upon model chosen) must only be replaced with a
complete and genuine replacement set and the fire must never be run with the
wrong number or damaged pebbles or coals. The fuel-bed must be carefully
re-assembled as stated in the following sections
38
Advertisement
Table of Contents
