Table of Contents
Advertisement
Servicing Notes
Servicing should be carried out annually by a competent person such as a GAS
SAFE registered engineer and must include an oxypilot change. This is a
condition of the Flavel guarantee schemes.
The service should include visually checking the chimney and fire opening for
accumulations of debris and a smoke test to check for a positive up-draught in the
chimney.
The condition of the coals or pebbles should be checked and if necessary the
whole set should be replaced with a genuine replacement set.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out. All sections apply for both coal and pebble fuelbed variants.
For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
Lift the trim and ash pan cover / fret out of the way and put
them in a safe location. Remove the loose pebbles or coals from the
fuel bed. Remove the front ceramic from the rail. Unscrew
the two pozi-driv fixing screws which secure the burner heat shield and
remove it from the fire.
4.1.3
Isolate the gas supply. Remove the inlet pipe from the appliance
pressure test point elbow Unscrew and remove the four
screws which retain the burner. Remove the burner assembly from the
fire. Disconnect the two leads from the on / off switch.
4.1.4
To refit the burner assembly. Push the base of the control panel fully
into the fire and secure with the four screws. Refit the gas supply pipe
and carry out a gas tightness test. Refit the burner heat shield then
refit the fuelbed referring to section 3.1 / 3.2 for the correct layout. The
trim and fret / ash pan cover can now be re-positioned.
4.2
Removing the Piezo Igniter (All models).
4.2.1
Isolate the appliance from the gas and electricity supply.
4.2.2
Remove the burner assembly as in section 4.1
4.2.3
Disconnect the ignition lead from the piezo and unscrew the
retaining nut on the rear of the control panel. Withdraw the piezo from
the front of the control panel. Re-assemble in reverse order and carry
SECTION 4
MAINTENANCE
31
Advertisement
Table of Contents
