Hardware Assembly - Flashforge Finder Quick Start Manual

Hardware Assembly

4
You can start up the Finder for printing after mounting the filament spool and completing leveling.
1. Remove the filament cartridge
the rear of Finder, where you will
place the filament spool.
4. Press the spring presser, and insert
the filament into the filament intake.
Your Finder has been installed before leaving factory.
in 2. Thread the filament through the filament
guide tube, pierce the filament through
the filament outlet and then place the
filament spool in the cartridge.
5. Insert the power cable into the
power input on the back of Finder.
3. Install the filament
cartridge
the Finder.
into