Loading Filament - Flashforge Finder Quick Start Manual

Loading Filament

6
Print Preheat
1. Press the power switch to the right of the screen, tap [Tools] and then tap [Filament] and [Load] successively.
Heating
14%
Extruder
2. The extruder will be heated up automatically. Once
heated, the filament will be drawn through the extruder.
Do not tap the return arrow to complete until the filament
exits the extruder steadily.
Filament
Tools
Setting Status
...
℃ / ℃
34 2 30
Cancel
HOME
Level Home Manual
About
Changing Filament
1. Tap [Preheat]--[Start] to the heat up the extruder.
2 After completing preheating, knob down the spring presser and .
pull out the filament.
3. Tap the return arrow, Insert the new filament into the filament intake,
tap [Tools]--[Filament]--[Load]. Once heated, the filament will be
drawn through the extruder. When the filament is extruded steadily,
it shows the success of the operation.
Note
Do not pull out the filament with force as it will damage the gears.
If the melted filament has cooled down in the extruder, please
repeat the steps above.
Load
Unload