First Print - Flashforge Finder Quick Start Manual

First Print

7
1 Set up the model in Flashprint, click [Print], and
then a selection dialog appears. In the print interface,
click [More Options] for further setup. Click [OK] to
slice and generate a .g file.
2 Copy this .g file into an USB stick and insert the
USB stick into the Finder. Turn on the Finder and
ensure the build plate has been leveled and the
filament has been loaded in the extruder.
3
Tap [Print] in the main menu of screen, and then
tap the USB icon in the middle to select the file
you want to print.
4 Once tap [Print], the Finder will start to heat the
extruder up automatically to the operating temper-
ature and then start the print.
Suggestions
1.Ensure that the build plate has been leveled before printing.
2.Ensure that the filament has been loaded in an appropriate approach.
3.Load the filament for a while to extrude the melted filament you printed last time out of the extruder.
4.Do not leave the Finder unattended during operation.
5.Remove the printed model with appropriate tool to avoid damaging the build plate and the model.
1
3
G
XXX.g
Load Copy
Delete
2
4
.
XXX g
Print time
0 : 00
0%
Extruder 30℃/220℃