Adjust The Seat Depth - Vermeiren Inovys II Instruction Manual

The wheel sockets in the frame tubing
The stability or manoeuvrability of the wheelchair can be adjusted over 50 mm.
STEERING WHEELS
In the standard model, the INOVYS II is delivered with two 8" steering wheels (200 mm x 50
mm or 200 mm x 35 mm).
3.5

Adjust the seat depth

WARNING:
Risk of injury – Make sure that all screws are secure and properly
   
tightened.
The seat depth can be adjusted in 3 positions (steps 20 mm). Adjust the seat depth
according following rules:
Note: When rebuilding the seat depth in the back frame area, the displacement of the spring
for adjusting the back is changed and a gap can occur between the back and seat cushions.
The seat depth can also be changed by adjusting the brackets of the backrest. With these
adjustment you can become a minimum seat depth of 460 mm.
DRIVING WHEELS
Four possible wheel sockets are provided in a
swage block of the frame for the use of driving
wheels (24")
suspensions are used to attach the driving
wheels, the
manoeuvrability of wheelchair: 45 mm) and the
seat height can be changed. The wheel sockets
attached in the delivery condition can be
attached in all sockets (bore holing)
serve only to attach 16" wheels (transit version).
Seat depth Hole
480 mm
500 mm
520 mm
Table 3: Seat depth
1. Loosen the screws
front seat frame.
2. Pull or push the front of the seat frame into
the desired position.
3. Retighten the screws
1. Remove the backrest.
2. Loosen the bolts c of the four
brackets.
3. Adjust the brackets more to the front
or back until the desired seat depth.
4. Retighten the bolts c of the four
brackets.
5. Replace the backrest.
ƒ‰‡
 (22") . Depending on which
wheel position
c
d
e
beneath the
firmly again.
Inovys II
2011-11
(stability or