Installation And Adjustment - Vermeiren Inovys II Instruction Manual

Steps to secure the wheelchair user:
1. Remove both arm rests.
2. If present, attach the wheelchair's pelvic belt.
3. Attach the occupant restraint belts according to the instructions of the strap-system
manufacturer.
4. Wear the pelvic belt low across the front of the pelvis, so that the angle of the pelvic
belt is within the preferred zone of 30° to 75° to the horizontal, similar to that shown
below.
5. A steeper (greater) angle within the preferred zone is desirable.
6. Adjust the belt tightly according to the instructions of the strap-system manufacturer,
consistent with the user's comfort.
7. Ensure that the restraint belt connects in a straight line to the anchor point in the
vehicle and that no bends in the belt are visible, for instance at the axle of the rear
wheel.
8. Install the arm rests, if desired. Make sure that belts are not twisted or held away
from the body by wheelchair components such as arm rests or wheels.
3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren multi-functional wheelchairs Inovys II has been designed entirely for your
comfort. This wheelchair can be adjusted to individual requirements as explained below.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
WARNING:
Risk of unsafe settings - Use only the settings described in this
   
manual.
WARNING:
Variation of allowed adjustments can still change the stability of your
   
wheelchair (tilt back or sideways).
ƒ‰‡
Inovys II
2011-11