Vermeiren Inovys II Instruction Manual page 20

WARNING:
Risk of injury - Check that the seat heights are mounted in the same
   
position on both sides.
WARNING:
Risk of tipping over - When the driving wheels are adjusted, the
   
position of the wheels are altered.
The seat height of the Inovys II multiposition wheelchair is adjustable in 3 positions in steps
of 35 mm. The seat height can be adjusted by moving the front tube
gas pressure spring
can find below the seat frame.
Front tube
The basic frame and the seat frame are screwed together with the front tube
frame three different sockets are provided for these screws which determine the
wheelchair's seat height.
Attachment plate gas pressure spring
In addition to adjusting the frame, the gas pressure spring for the seat inclination can be
fixed at three different attaching heights
the seat inclination, the assembly height of the gas pressure spring
the assembly height of the front tube
Rear wheel plate
The rear wheel plate
WARNING:
Risk of tipping over – Be aware that you change the stability of the
   
wheelchair when changing the position of the driving wheels.
WARNING:
Risk of injury – Make sure that the rear wheels on both sides are
   
mounted in the same position.
and rear wheel plate
Seat height
460 mm
495 mm
530 mm
Table 2: Seat heights
. So that the angle of inclination can be kept for
.
must correspond to the assembly height of the front tube
ƒ‰‡
, attachment plate
in different positions. These components you
Part
       
Hole 1
Hole 2
Hole 3
Inovys II
2011-11
. In the basic
must correspond to
.