Use; Carrying The Wheelchair; Mounting The Rear Wheels (Only For Quick Release 22", 24" Rear Wheels); Mounting Or Removing Of The Footrests - Vermeiren Inovys II Instruction Manual

2

Use

This chapter describes the everyday use. These instructions are for the user and the
specialist dealer.
The wheelchair is delivered fully assembled by your specialist dealer. The instructions
intended for the specialist dealer on how to set up the wheelchair are given in § 3.
2.1

Carrying the wheelchair

The best way to carry the wheelchair is to make use of the wheels and roll the wheelchair.
If this is not possible (e.g. when the rear wheels are taken off for transportation in a car),
firmly grasp the frame on the front and the back. Do not use the foot or arm rests or the
wheels to grasp the wheelchair. At least two persons are required for transporting the
wheelchair.
2.2 Mounting the rear wheels (only for quick release 22", 24" rear
wheels)
2.3

Mounting or removing of the footrests

WARNING:
Risk of injury - Make sure that the footrests are firmly locked before
   
using the footrests.
1. Take the rear wheel and push on button
2. Keep the button pushed in and mount the rear
wheels axle till it stops.
3. Release the button.
4. Check that the wheel is secured.
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchair frame and mount the tube hood
into the frame.
2. Swing the footrest inwards till it clicks in
position.
3. Swing the foot plate downwards.
To take off the footrests:
1. Pull lever upwards.
d
2. Swing the footrest to the outside of the
wheelchair till it comes loose from the guidance.
3. Pull the footrest from tube hood
ƒ‰‡
Inovys II
2011-11
.
c
c
.
c