Modifying The Lan Interface (Nat / Routing) - Planet CS-2001 User Manual

3.1.1 Modifying the LAN Interface (NAT / Routing)

Prerequisite Setup (Note: IP addresses used as examples only)
Port1 is configured as LAN1 by default. (IP address: 192.168.1.1, NAT/ Routing)
Step 1. Go to Network > Interface and then set as below:

Click Port1's Modify button.

Select LAN for Interface Type.

Select NAT Routing for Connection Type.

Enter the IPv4 Address and Netmask.

Tick Ping, HTTP and HTTPS.

Click OK.
Note：
1. The LAN subnet is configured as 192.168.1.x/24 by default. After modifying the LAN subnet,
LAN PCs' subnet must be modified as well for the LAN users to access the Web UI.
Figure 3-1 Modifying the LAN Interface
85
（Figure 3-1）