Crimping A Bnc Connector; Order No. M578527Ac/112003 - videotronic HQ-IDC-23012P Operating Instructions Manual

Annex
4.6

Crimping a BNC Connector

1. Preparing the coaxial cable
G Before the rubber cap can be slipped onto
the end of the cable that is to be crimped,
you first have to lubricate the end of the
cable.
G To do this, dip about 10 cm of the coaxial
cable into methylated spirits.
G Now slide the rubber cap (with the smaller
diameter first) about 10 cm onto the cable
and the crimping sleeve for about 5 cm.
G Now strip the insulation from the end of the coaxial cable using a coax cable
stripper.
cable stripper, e.g. KAB−828
Fig. 68 Preparing the coaxial cable
HQ−IDC−23012P

Order No. M578527AC/112003

© 2003 videotronic gmbh
ALL RIGHTS RESERVED
BNC−C2
(Article No. 568608)
Crimp sleeve
Fig. 67 Preparing the coaxial cable
BNC−C3
Coaxial cable stripper with 2 blades
e.g. KAB−59
(Article No. 568600)
RG−62
S
RG−59
53