Motion (Motion Detection) - videotronic HQ-IDC-23012P Operating Instructions Manual

3.2.16

MOTION (Motion Detection)

In this menu you enable the motion detection. To do this, you have to specify
an alarm zone in which a movement will trigger a message. You will receive the
message on the monitor.
G Move the arrow
to the <MOTION> menu.
G Press the <ENTER> key to open the input
mode.
G Press <UP> or <DOWN> to change the
selection from OFF to ON.
G Press the <ENTER> key to open the input
mode.
G Press the <UP> or <DOWN> keys to open
the corresponding submenu.
AREA
In this submenu you can specify the area
in which a movement will lead to an alarm.
G Press the <ENTER> key to open the input
mode.
G Move the flashing zone indicator (A) to
the zone you wish to select, e.g. (B),
using the <UP> or <DOWN> keys and
press the <ENTER> key.
' This zone will be selected and then
appears in grey.
G Move the flashing zone indicator (C) to
the next zone you wish to select using the
<UP> or <DOWN> keys and press the
<ENTER> key.
G Select all zones using the method
described above.
G Press the <ESC> key to quit the
submenu.
38
with the <Down> key
SETUP MENU [3/4]
POSITION
H−GAIN
V−GAIN
MOTION
IR
INITIAL
Fig. 43 MOTION
MOTION
AREA
LEVEL
TIME
OSD
Fig. 44 MOTION
A B C
Fig. 45 MOTION
HQ−IDC−23012P
Order No. M578527AC/112003
© 2003 videotronic gmbh
ALL RIGHTS RESERVED
Configuration
SAVE
+6
+6
ON.
ON.
ON
+4
10sec
ON