Pitney Bowes da95f Operator's Manual page 71

Address
smudging
Skewed print
Unwanted
bolding
Misaligned
test print
Addresses
walking
SV61749 Rev. D
Incorrect media
thickness knob
setting.
Ink may not dry
on very high gloss
material.
Dirty exit rollers
Side guide set
incorrectly.
Roller or wiper is
running along the
edge of the media.
Escape sequence
turning on bold, or
bold selection in
printer's menu options
is set to bold.
After replacing
ink cartridge test
print is stepped or
misaligned.
Incorrect Address
Setup
Address Termination
should be Form Feed.
Troubleshooting • 4
Check whether media thickness
knob is adjusted too low. See
Chapter 2, Printer Basics.
Try using less glossy material or
running the job in light mode or
setting print quality mode lower.
You can also try increasing the
feed gap slightly.
Remove and excess buildup
with soft cloth dampened with
water.
Side guide should control media
without restricting feed.
Move the print head module to
a slightly different position over
the media.
Turn off bolding in software
and/or turn bold selection in
printer menu OFF. See Chapter
2, Printer Basics. If problem still
exists, call Pitney Bowes for
service.
Contact your machine supplier.
Count cartridge returns and
line feeds and adjust lines per
address to the same number.
Set address setup for 8 lines.
Check Line Termination: Typical:
CR=CR; LF=LF. other choices
(CR=CR+LF;LF+LF)
(CR=CR;LF=CR+LF)
(CR=CR+LF; LF=CR+LF)
4-7